LICENSED LOCAL PLUMBERS ACROSS 53 IPSWICH SUBURBSRedbank Plains, Ipswich · Queensland
TOILETS · 3 MINUTE READ

Toilet not flushing?
Lift the lid and see.

THE SHORT ANSWER

Lift the cistern lid. No water in the cistern means the supply is the problem: the small tap at the wall is closed, or the inlet valve is stuck. A full cistern that will not empty means the button or the flush valve has come adrift or broken. A cistern that empties but gives a weak flush, or a bowl that fills and drains slowly, points to a partial blockage. Until it is fixed, half a bucket of water poured into the bowl flushes it.

Open toilet cistern with gloved hands adjusting the inlet fill valve
With the lid off you can see whether the cistern fills, and whether the button moves the flush valve.
FIVE MINUTES

Find the cause
in five steps.

  1. Lift the lid

    Most lids lift straight off. If the buttons are in the lid, unscrew the button ring first, and lift gently: some have a cable or rods attached.

  2. Check the water level

    Empty or low: check the small tap at the wall is open (anticlockwise), then watch whether the inlet valve lets water in.

  3. Press the button and watch

    The button should push a rod or pull a cable that lifts the flush valve in the middle. If nothing moves, it has come adrift.

  4. Watch the bowl

    If the cistern empties but the water in the bowl rises and drains slowly, the problem is a blockage, not the cistern.

  5. Flush with a bucket

    Pour half a bucket of water into the bowl in one go. If that flushes normally, the fault is in the cistern.

QUESTIONS

Quick answers.

Why is my toilet not flushing?

Lift the cistern lid. An empty cistern means the supply tap is closed or the inlet valve is stuck. A full cistern that will not empty means the button or flush valve has disconnected or failed. If the cistern empties but the bowl does not clear, there is a blockage.

Why is my toilet cistern not filling with water?

Check the small isolation tap at the wall is open. If it is, the inlet valve is stuck or blocked with grit or scale, or the float is caught. A plumber can clean or replace the valve.

Why is my toilet flush weak?

The water level in the cistern is too low, the flush valve closes too early, the holes under the rim are blocked with scale, or there is a partial blockage in the pan or drain. Check you are not pressing the half-flush button.

Can I flush a toilet when the cistern is not working?

Yes. Pour half a bucket of water into the bowl in one quick go. The rush of water pushes the contents through the trap, which is all the cistern does.

How much does it cost to fix a toilet that will not flush?

Repairing a toilet cistern is typically $150–$350. Supplying and fitting a new toilet suite is typically $400–$1,000, and unblocking a toilet is typically $95–$180.

MORE GUIDES

Keep reading.

All guides
NO GUESSWORK

Toilet still
not flushing?

Send what happens when you press the button, what you see in the cistern, and your suburb. A licensed local plumber who covers the area gets back to you.

Get a local plumber
CallTextGet a local plumber