LICENSED LOCAL PLUMBERS ACROSS 53 IPSWICH SUBURBSRedbank Plains, Ipswich · Queensland
STORMWATER · 3 MINUTE READ

Sump pumps:
when water cannot run downhill.

THE SHORT ANSWER

A sump pump sits in a pit (a pump well) at the low point of a block, a basement or a driveway that slopes down to a garage. Stormwater drains into the pit, a float switch turns the pump on as the water rises, and the pump pushes it uphill to the kerb or a council drain. If the pump fails in a storm, the pit overflows. Test it before every wet season by filling the pit with a hose.

Water running from a downpipe into a stormwater grate beside a lawn
Stormwater has to reach the legal point of discharge. On a low block, a pump gets it there.
BEFORE THE STORMS

Test it
in five steps.

  1. Lift the lid

    Find the pump well and lift the lid. Check the pit for silt, leaves and rubbish around the pump and the float.

  2. Fill it with a hose

    Run a hose into the pit. As the water rises, the float should lift and the pump should start.

  3. Watch it empty

    The water level should drop quickly and the pump should switch off by itself. Check water comes out at the outlet.

  4. Test the alarm

    If there is a high-water alarm, lift its float by hand or keep filling until it sounds.

  5. Clean the pit

    Scoop out silt and debris, and check the inlet grates are clear. Silt wears the pump and jams the float.

QUESTIONS

Quick answers.

What does a sump pump do?

It pumps stormwater from a pit at the low point of a property up to the street kerb or a council drain, where the water could not get by gravity. A float switch turns it on when water rises in the pit.

How do I test my sump pump?

Lift the lid and fill the pit with a hose. The float should rise, the pump should start, the water should drop quickly and the pump should stop by itself. Test any high-water alarm too.

Why does my sump pump keep running?

Usually the float is stuck in the up position, or the non-return valve has failed so the same water keeps flowing back into the pit. A pump that never stops can burn out, so have it checked.

How often should a sump pump be serviced?

Test it yourself before every wet season and after any big storm. Have a plumber service it every year or two: clean the pit, check the pump, the floats and the non-return valve.

How much does it cost to fix a sump pump?

A plumber’s call-out and first hour is typically $170–$300, which covers testing and most float or valve repairs. Clearing a blocked stormwater outlet is typically $200–$600.

MORE GUIDES

Keep reading.

All guides
NO GUESSWORK

Pump well not
keeping up?

Send what happens in rain, the pump age if you know it, and your suburb. A licensed local plumber and drainer who covers the area gets back to you.

Get a local plumber
CallTextGet a local plumber