A tap that drips from the spout when it is turned off almost always has a worn washer (on a two-handle tap) or a worn ceramic cartridge (on a mixer). In Queensland you can replace a tap washer or jumper valve yourself. Anything more, such as a mixer cartridge, the tap itself or the pipework, is work for a licensed plumber.
A mixer has a ceramic cartridge inside, not a washer. Replacing it is a licensed job in Queensland.
TWO-HANDLE TAPS
How to change a tap washer in five steps.
Turn the water off
At the meter by the front boundary, or the isolation valve under the sink if there is one. Open the tap to drain what is left.
Take the handle off
Put the plug in so nothing falls down the drain. Unscrew or lever off the handle and the cover (shroud) under it.
Unscrew the spindle
Use a spanner on the large nut (the headgear) and lift the spindle out.
Swap the washer
The jumper valve and washer sit in the tap body. Take the old one to the hardware shop to match the size. Replace the O-ring on the spindle while it is out.
Reassemble, turn on slowly
Do it up firm, not tight. Turn the water back on slowly and check for drips.
Where it leaks tells you the part
From the spout, when turned off: the washer, or the seat it presses on.
Around the handle or spindle when the tap is on: the O-ring on the spindle.
From the base of the tap or spout: the body washer or the spout O-ring.
Under the sink: the braided flexi-hose or its connections. Replace a rusty or bulging hose before it bursts.
A mixer that drips or will not shut off: the ceramic cartridge.
If it still drips with a new washer
The brass seat the washer presses on is pitted. A reseating tool can recut it, or a plumber can do it in a few minutes. Do not just tighten the tap harder: that chews through the new washer and wears the seat further.
When to call a plumber
For any mixer tap, a seat that will not reseat, a tap that is seized or corroded, a leak inside the wall, or a flexi-hose that needs changing. Supplying your own tap is fine; check with the plumber before you buy that it suits the fittings you have.
A tap dripping once a second wastes thousands of litres a year, so it is worth fixing soon either way.
Typical cost: A plumber typically charges $80–$260 to fix a leaking tap in Ipswich. See the price guide.
You can replace a tap washer or jumper valve yourself. Replacing a mixer cartridge, the tap itself or any pipework is plumbing work that needs a licensed plumber.
Why is my tap still dripping after I changed the washer?+
The seat the washer presses against is worn or pitted. It needs recutting with a reseating tool, or the tap needs replacing.
How much does it cost to fix a leaking tap in Ipswich?+
Typically $80–$260 for a plumber to fix a leaking or dripping tap, or $90–$160 for a washer or O-ring alone. Replacing a mixer, supplied and fitted, is usually $200–$500.
Why does my mixer tap drip?+
Mixers do not have washers. The ceramic cartridge inside wears or gets grit in it. The cartridge is specific to the brand and model, so note the brand before the plumber comes.
Is a leaking tap urgent?+
A drip is not an emergency, but it wastes water and wears the tap. A leak under the sink from a flexi-hose is more urgent: those can burst and flood the room.