How a septic tank works
Homes that the sewer does not reach, which around Ipswich means many acreage and rural blocks, treat their own wastewater on site. Everything from the toilets, showers, sinks and laundry runs into one buried tank, usually concrete or plastic and holding 3,000 litres or more.
Inside, the flow slows right down. Heavy solids sink and form a layer of sludge. Fats and grease float to the top as scum. Bacteria that live without air digest part of both. A baffle or T-piece at the outlet holds the scum and sludge back, so only the liquid in the middle leaves the tank.
That liquid, called effluent, runs to an absorption trench: slotted pipe in a bed of gravel. It soaks into the soil, and the soil bacteria finish cleaning it. The tank is only half the system. The trench is the other half, and the more expensive one to replace.
Septic tank or treatment plant?
Many newer homes have an aerated wastewater treatment system instead. It looks similar from above but has a power supply, an air blower, a pump and an alarm. It treats the water further and then irrigates it through garden beds or under the lawn.
A treatment plant needs servicing by a licensed technician, usually every three months under a service agreement, as well as an occasional pump-out. If there is an alarm light or a control box near the tank, you have a treatment plant.
How often to pump it out
Most septic tanks need pumping every 3 to 5 years: sooner with five or more people in the house or a small tank. The sludge layer grows a little every day. Once it is deep enough, solids wash out with the liquid and clog the gravel and soil in the trench. A pump-out is a small bill next to a new trench.
A licensed liquid waste contractor pumps the tank through the main lid and takes the waste to a treatment facility. Ask them to check the baffles while the tank is empty, and keep the receipt.
Signs it is full or failing
- Toilets and drains across the whole house run slowly or gurgle.
- A sewage smell near the tank, the trench or the gully outside.
- Wet, spongy ground or pooling water over the trench, especially in dry weather.
- A strip of grass over the trench that is much greener than the rest of the lawn.
- Sewage backing up at the lowest drain in the house.
- On a treatment plant: the alarm sounding or the light on.
Who does what
A liquid waste contractor pumps the tank. A licensed plumber and drainer clears and repairs the pipe from the house to the tank, the baffles, the outlet and the trench. Installing, replacing or altering a septic system in Queensland needs a plumbing approval from the council before work starts.
If the drains are slow and the tank was pumped recently, the cause is more likely a blocked pipe into the tank or a failed trench than a full tank.
Typical cost: The liquid waste contractor quotes the pump-out. A plumber clearing a blocked drain into the tank is typically $180–$550. See the price guide.
