The pressure limiting valve: the cap on your water pressure.
THE SHORT ANSWER
A pressure limiting valve is a small brass valve on the pipe where water enters the property, usually just after the meter. It holds the pressure in the house at about 500 kPa whatever the mains is doing. Without one, or with a failed one, high pressure wears out taps, flexi-hoses, toilet valves and the hot water system. A worn one can also do the opposite and choke the flow.
A pressure limiting valve is a small brass fitting, replaced in under an hour.
THE SIGNS
Four clues it has failed.
Banging pipes
Water hammer when taps or the washing machine shut off, worse late at night when mains pressure rises.
A relief valve that keeps dripping
The hot water system’s relief valve dribbling all day, not just while heating, points to high pressure.
Parts that keep failing
Burst flexi-hoses, toilet inlet valves that hiss, and taps that need washers every year.
Or the opposite: weak flow everywhere
A valve clogged with grit, or stuck part closed, starves the whole house.
Why pressure is limited
Mains pressure varies along a street and through the day, and in parts of Ipswich it runs well above what household fittings are built for. The plumbing standard limits pressure at outlets in new homes to 500 kPa. Appliance and tapware warranties commonly require it too. Many older homes were built before the valves were fitted as standard and have never had one.
Testing the pressure
A plumber screws a gauge onto a garden tap and reads the pressure with nothing running. It takes a minute and settles the question. Ask for it to be read late in the evening if you can, when pressure peaks.
Replacing one
The valve sits near the meter or where the pipe enters the house. They last about ten years. Replacement is a short job for a licensed plumber: water off, valve swapped, pressure checked on the gauge.
Typical cost: A plumber’s call-out and first hour is typically $170–$300 in Ipswich, plus the valve. See the price guide.
It caps the water pressure coming into the house, usually at 500 kPa, to protect taps, hoses, appliances and the hot water system from high mains pressure.
How do I know if my water pressure is too high?+
Banging pipes, a hot water relief valve that drips constantly, flexi-hoses or toilet valves failing early, and taps that spit when opened. A plumber can measure it with a gauge in a minute.
Where is the pressure limiting valve?+
Usually just after the water meter at the front boundary, or where the supply pipe enters the house. Some homes have one only on the hot water system’s inlet.
How long does a pressure limiting valve last?+
About ten years. Grit and scale shorten that.
How much does it cost to fit a pressure limiting valve in Ipswich?+
Usually a call-out and first hour, typically $170–$300, plus the valve.